1859
Color: Clear
Axeon Non-PVC Inks
AXEON™ Glitter Base 1859 works as a carrier for metallic and colored glitter flake designs.
Glitter Base 1859 allows for infinite creativity with designs and can be mixed with multiple colors glitter flake sizes.
Glitter Base 1859 adheres strongly with metallic or colored glitter flake for excellent durability.
AXEON™ Glitter Base 1859 works as a carrier for metallic and colored glitter flake designs.
Glitter Base 1859 allows for infinite creativity with designs and can be mixed with multiple colors glitter flake sizes.
Glitter Base 1859 adheres strongly with metallic or colored glitter flake for excellent durability.
This product will spot dry, with a very low after flash tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift off, but not totally fused. Totally fusing the underprint may cause inter-coat adhesion problems with the inks printed on top. Final fusing or curing will occur in the dryer. Failure to fuse ink properly may cause cracking, poor adhesion and poor wash fastness.
It is extremely important to preprint and test printed fabrics for wash and wear durability before beginning production.
A forced air dryer is highly recommended for proper curing/fusion of this product.
Complete fusion of this product may be very difficult to achieve in an infrared dryer since metallic glitter flakes reflect infrared heat.
For best durability of the glitter print after it is applied, it is recommended that the garment be hand washed or machine washed (delicate cycle) inside out and line or air dried. Do not use bleach. Do not iron over printed areas.
Test dryer temperatures and wash test printed product before and during a production run.
This ink and those in the AXEON™ product line are not formulated with PVC resins and phthalate plasticizers, nor are they intentionally added.
Care should be taken to not cross-contaminate the AXEON™ products with PVC or phthalate containing products.
Do not use standard plastisol curable reducers with this or any of the AXEON™ products.
Recommendations and statements made are based on International Coatings’ research and experience. Since International Coatings does not have any control over the conditions of use or storage of the product sold, International Coatings cannot guarantee the results obtained through use of its products. All products are sold and samples given without any representation of warranty, expressed or implied, of fitness for any particular purpose or otherwise, and upon condition that the buyer shall determine the suitability of the product for its own purpose. This applies also where rights of third parties are involved. It does not release the user from the obligation to test the suitability of the product for the intended purpose and application.
100% Cotton
Some Cotton/Polyester Blends
Mix with flake prior to use. Stir well! Add up to 25% - 30% of flake to base
Not recommended
110–305 t/in (43–120 t/cm) monofilament.
Any direct or indirect solvent resistant emulsion or capillary film in the 35 to 70 micron range
65–70 Durometer, sharp edge.
325°F (163°C) entire ink film.
320ºF (163ºC) for 60-90 seconds. Metallics reflect heat, so adjust dwell time accordingly.
Quart
1 Gallon
5 Gallon
65°F to 90°F (18°C to 32°C). Avoid storage in direct sunlight. Keep containers well sealed.
Any eco-friendly plastisol type screen wash
Plastisol Inks
SKU: 1855
Plastisol Inks
SKU: 1856
Plastisol Inks
SKU: 1857
Explore our diverse range of products designed to meet your unique needs and applications.
Learn more